Skip to content
No Second Trip

Guides

How much concrete do I need?

Work out concrete in cubic yards from your slab dimensions, convert it to bags, and find the point where a ready-mix truck becomes cheaper than mixing it yourself.

Updated

Wet concrete running down a truck chute into a timber-formed slab, with reinforcing mesh visible in the unpoured section.

The short answer: a 4 inch slab needs one cubic yard for every 81 square feet. Divide your square footage by 81 and you have your yards.

That works because a cubic yard is 27 cubic feet, and spreading 27 cubic feet four inches deep covers 81 square feet. For any other thickness, divide 324 by the depth in inches to get the coverage per yard.

Cubic Yard Calculator

Convert length, width and depth into cubic yards for concrete, topsoil, mulch, sand or stone — and see what that volume actually weighs before you order it.

Full cubic yard calculator, with formulas and sources

Section through a concrete slab and its baseA cut-through view of a slab on ground. From the bottom: compacted subgrade, then four to six inches of compacted aggregate base, then a four inch concrete slab. The slab edge is thickened to twelve inches where it meets the perimeter. Arrows mark the slab thickness and the base depth.Compacted subgradeCompacted aggregate baseConcrete slab4 in slab4–6 inThickened edgeOrder for the forms, then add 5–10%Sub-grade is never flat, and the low spots are real volume
A slab is two materials. The base spreads the load and drains water; the concrete is the wearing surface — and most slab failures start underneath.

The arithmetic, step by step

For a 20 ft × 10 ft patio at 4 inches:

  1. Area — 20 × 10 = 200 sq ft
  2. Depth in feet — 4 ÷ 12 = 0.333 ft
  3. Volume — 200 × 0.333 = 66.7 cu ft
  4. Waste — 66.7 × 1.10 = 73.3 cu ft
  5. Cubic yards — 73.3 ÷ 27 = 2.72 cu yd
  6. Weight — 73.3 × 150 ÷ 2,000 = 5.5 tons

Step 2 is where nearly every mistake happens. If you multiply 200 square feet by 4 without converting the inches to feet, you get 800 cubic feet — twelve times too much, and a very expensive phone call.

How thick does it need to be?

UseThicknessNotes
Footpath, shed base4 inOver 4 in of compacted base
Patio4 in5 in if a hot tub is going on it
Driveway, car parking5 in6 in where a truck turns
Garage floor5–6 inThickened to 8–12 in under any bearing wall
FootingsPer codeStructural — size it from your local requirements

The base under the slab does more work than the last inch of concrete. Four inches of well-compacted aggregate under a 4 inch slab outlasts a 6 inch slab poured on soft ground, because the failure mode is settlement, not crushing.

Bags or a truck?

The crossover is about one cubic yard, which is 45 eighty-pound bags.

Bag sizeYield per bagBags per cubic yard
40 lb0.30 cu ft90
50 lb0.375 cu ft72
60 lb0.45 cu ft60
80 lb0.60 cu ft45

Use the yield printed on the bag rather than working from its weight — mixed concrete takes up less volume than the dry powder does, so an 80 lb bag makes 0.60 cubic feet, not the 0.85 its bulk suggests.

The stronger argument for a truck is consistency rather than cost. A delivery is one batch at one water-cement ratio, placed in a single pour. Forty-five bags is forty-five separate mixes, each slightly different, with the first ones going off while you are still mixing the last. For a structural slab, or one that has to look uniform, that difference is visible.

Ready-mix suppliers usually have a one-yard minimum and a short-load fee below it. Ask what the fee is before assuming the truck is uneconomic — it is often less than the extra bags would have cost.

Never run short mid-pour

Concrete has to go down as one continuous placement. If the truck empties before the forms are full, the join between what has set and what comes next is a cold joint — a permanent plane of weakness through the slab. Ordering five to ten percent over is cheap insurance against it.

What a cubic yard weighs

About 4,050 lb, or just over two tons, at 150 lb per cubic foot. That matters for three reasons: whether your driveway can take the truck, whether a wheelbarrow route can carry the load, and how many trips it takes if you are moving it by hand. A wheelbarrow holds around 3 cubic feet, so one cubic yard is nine full barrows of roughly 450 lb each.

Related

Common questions

How much concrete do I need for a 10x10 slab?

A 10 ft × 10 ft slab at 4 inches thick is 1.23 cubic yards, or about 1.36 cubic yards with a 10% waste allowance. That is 62 eighty-pound bags, which is well past the point where a ready-mix truck is worth pricing.

How many 80 lb bags of concrete make a cubic yard?

Forty-five. An 80 lb bag yields 0.60 cubic feet of mixed concrete, and there are 27 cubic feet in a cubic yard. For 60 lb bags it is 60, and for 40 lb bags it is 90.

How thick should a concrete slab be?

Four inches for patios, sheds and paths, and five to six inches anywhere a vehicle drives or parks. A properly compacted sub-base matters more to how long the slab lasts than any extra inch of concrete does.

Should I order extra concrete?

Yes. Five percent is sensible for a formed slab on a prepared base, and ten percent on open ground where the sub-grade is uneven. Running short mid-pour leaves a cold joint through the middle of the slab, which is a permanent weakness.

Calculators for this

  • Cubic Yard Calculator

    Convert length, width and depth into cubic yards for concrete, topsoil, mulch, sand or stone — and see what that volume actually weighs before you order it.

Part of our concrete guide.

Reviewed by Quban, Construction estimator, on . How these numbers are checked.